Offshoreonly.com - Have to raise port motor 1 inch

Page 3 of 3

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- Fountain (https://www.offshoreonly.com/forums/fountain-37/)

- - Have to raise port motor 1 inch (https://www.offshoreonly.com/forums/fountain/272904-have-raise-port-motor-1-inch.html)

mcprodesign

03-24-2012 03:56 PM

Quote:

Originally Posted by 575cat (Post 3648335)

So your saying the tail pipes are low with the engine or drive ??

It's 1/2 at the gimble. 1/4 of bottom gone from blueprinting. Probly just have to raise back of motor 1/2. leave front mount alone. Not too thrilled about a new set of holes about 5/8 or so from old ones. Exhaust is a long story. Getting ready to test it here in a little bit.

Marginmn

03-25-2012 07:58 AM

How does the boat run now - are there any odd characteristics with its performance?

Racerngr1

03-25-2012 11:00 AM

That boat looked bad ass running yesterday, I don't think I would touch it.

If you REALLY wanted to have it done, I would go talk to the Camire's at Lavey Craft in Corona.

mcprodesign

03-25-2012 11:26 AM

Quote:

Originally Posted by Marginmn (Post 3648610)

How does the boat run now - are there any odd characteristics with its performance?

That is my same question. What is it actually costing me? Boat ran faster and better than ever yesterday

All times are GMT -5. The time now is 10:03 AM.

Page 3 of 3

Show 40 post(s) from this thread on one page