|
Originally Posted by KWright
(Post 3758355)
On the front of your thermostat housing you have
4 hoses that go to your exhaust manifold. The two That come out just over the hose that comes from Your water pump, pull them off and check to make sure the check balls are not stuck open. |
Originally Posted by Broomes Isle Joe
(Post 3758847)
you might want to check the fitting for the drive water hose, you need to pull the feed hose for the rwp off of the transom fitting remove the 2 -7/16 head screws that attach the black plastic water outlet to the transom plate[behind motor] and inspect the water hose fitting have seen quite a few corrode close restricting water supply
|
the hose is held in with an internal plastic cone shaped fitting ,that collapses from corrosion , most fountains have a ball valve shutting the water off to the drive when flushing so unless you let the water run before closing the valve your not flushing the transom,just the engine, probably not your problem though if the boats only been in the salt for 1 year
|
Originally Posted by Broomes Isle Joe
(Post 3759296)
the hose is held in with an internal plastic cone shaped fitting ,that collapses from corrosion , most fountains have a ball valve shutting the water off to the drive when flushing so unless you let the water run before closing the valve your not flushing the transom,just the engine, probably not your problem though if the boats only been in the salt for 1 year
Any other things I should check? Thanks |
lower unit
see if the water inlet top 3 holes have plugs in them.....mine does so when the boat gets up to speed the top holes come out of the water suckin air....just a suggestion if not call bill schuemaker at 317-862-3919
|
| All times are GMT -5. The time now is 06:22 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.