My New JC Performance Mill!!!!!!!!
#3
Re: My New JC Performance Mill!!!!!!!!
Originally Posted by Titan
Just got back from Zul's. Check out my new mill for 2005!!
It is still hard for me to realize that he can actually build a motor.....
Sweet!!! WE NEED #S!!!!!!!!!!
#4
Registered
Thread Starter
Join Date: Oct 2002
Location: Mill Neck, NY
Posts: 2,275
Likes: 0
Received 0 Likes
on
0 Posts
Re: My New JC Performance Mill!!!!!!!!
Jeff built mine. On the dyno. The other is going in a Skater. Not sure who built them but were waiting for dyno....
#5
Registered
Re: My New JC Performance Mill!!!!!!!!
Originally Posted by masher44
It is still hard for me to realize that he can actually build a motor.....
Sweet!!! WE NEED #S!!!!!!!!!!
Sweet!!! WE NEED #S!!!!!!!!!!
#7
Re: My New JC Performance Mill!!!!!!!!
Originally Posted by JCPERF
I have a hard time realizing it too you jacka s s
It looks like there is room for an Upper Deck in that blower
Then you can give Mascara a Dry Dock in his cabin before he gets his boat back....
Where have you been? at NYDOT stealing yellow highway paint for those valve covers....?
I will call you tomorrow...might have the beak sold .....
#8
Registered
Re: My New JC Performance Mill!!!!!!!!
Originally Posted by masher44
It looks like there is room for an Upper Deck in that blower
Then you can give Mascara a Dry Dock in his cabin before he gets his boat back....
Where have you been? at NYDOT stealing yellow highway paint for those valve covers....?
I will call you tomorrow...might have the beak sold .....
Then you can give Mascara a Dry Dock in his cabin before he gets his boat back....
Where have you been? at NYDOT stealing yellow highway paint for those valve covers....?
I will call you tomorrow...might have the beak sold .....
#9
VIP Member
VIP Member
Re: My New JC Performance Mill!!!!!!!!
Originally Posted by sutphen30
so when will that be.
nice job,look good till the oil leaks out the bottom.
nice job,look good till the oil leaks out the bottom.
#10
Registered
Thread Starter
Join Date: Oct 2002
Location: Mill Neck, NY
Posts: 2,275
Likes: 0
Received 0 Likes
on
0 Posts
Re: My New JC Performance Mill!!!!!!!!
Originally Posted by offshoredrillin
He had his irish helper with him...plenty Oducttape... and his Italian friend too Lotsa Silicone
I like the Irish Joke "ODucttape"!! But easy on the Italien jokes... Silicon is only used to keep the oil pan on This way to change the oil all you have to do is tug at it a little. No draining through a little tube. But that is a secret so don't let on or TMP will start doing that also....