BGIII

iTrader: (3)

How's the engine working going Crazyhorse?

Crazyhorse

I think we're going to run the first one Monday or Tuesday. Depends on when the MSD shows up. Got it pretty much buttoned up today.

fred

What all did you end up doing on them Dave?....Fred

fred

Are they getting dynoed?...if so let us know the numbers....Fred

Crazyhorse

Fred, good to hear from you. No, we're not going to dyno them, just run for cam break-in. Bored +.030, decked, align-honed, balanced, resized the rods w/ARP bolts, Federal Mogul cams (same as Dyno's and Waterfoul's), Cloyes timing chains, new valves, springs, retainers, and keepers in the Merlin heads, L2465F TRW+.030 pistons. Any progress on the Eagle? It's a great boat.

fred

Showed my boat yesterday....have to have it gone before I can move anywhere on the Eagle...(wifes rule)the Eagle is sitting ...waiting for me to fall prey on it!....Fred

fred

Those motors should be plenty for superv's boat, it was prety fast with the old set-up...Fred

Crazyhorse

We went from 8.75 to 9.7:1 compression ratio but the cam is a little less than the Bulldog cams he had last year. It should run about the same but the valve train should last longer as the springs are set at 110 lbs closed. Good luck on selling the 30. It's a good boat and should be about bulletproof for the next owner. You going to be in rack storage at GLM this year?

[ 01-19-2002: Message edited by: Crazyhorse ]

Crazyhorse

I think KAAMA is running Ultradynes.

Tinkerer

I have run ultradyne cams for about 10 yrs. now. I haven't had any problems other than my own fault.