Removing nose cones
I need to remove the nose cones on a set of B-One's. Does anyone have any ideas on how to do this?
|
Re: Removing nose cones
I did it once with TRS drives. They were the stainless steel type which were applied with some sort of adhesive.
I chipped/ground out the fairing epoxy to the edge of the nose cone & then put a block under the drive (not the nose cone) & gave the cone one good wack with a medium/small sledge hammer. They popped right off |
Re: Removing nose cones
I was thinking the samething. Thanks
|
Re: Removing nose cones
1 Attachment(s)
I was going to take one of an Alpha, but when I got the sorry epoxy job taken off, I found the water intakes were full of epoxy, so now I'm just going to fair it back in.
|
All times are GMT -5. The time now is 11:52 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.