380k-planes
#1
Registered
Thread Starter
Join Date: Aug 2004
Location: louisville, kentucky
Posts: 1,560
Likes: 0
Received 3 Likes
on
3 Posts
380k-planes
I tried posting this in the tech area. I am in need of two 380k-planes (just the actual "plane" or tab), to modify existing 280s to the 380 length. I need the style to fit a 1990 tab. Does anyone on the board have leftover tabs of the older style? Or where could I find a set of used ones to repaint if needed? We need them asap, if anyone knows any leads, etc. it would be very appreciated. Thanks
#4
BRAD SCHOENWALD
Platinum Member
You can use the new 380 plates. Order new plates, new lower pins, the busihings, and washers.
Call Brownie at Stainless Marine and order a new end piece for the trim indicator cable attachment.
Remove the trim hydralic cylinder and cut each side equally with clearance to fit inside the tabs.
Verify clearance on the inside edge of the tab to verify your drives will not hit the tabs at ny setting.
Call Brownie at Stainless Marine and order a new end piece for the trim indicator cable attachment.
Remove the trim hydralic cylinder and cut each side equally with clearance to fit inside the tabs.
Verify clearance on the inside edge of the tab to verify your drives will not hit the tabs at ny setting.
#5
Registered
Thread Starter
Join Date: Aug 2004
Location: louisville, kentucky
Posts: 1,560
Likes: 0
Received 3 Likes
on
3 Posts
Open: Thanks, i just contacted the guy with the tab, but ill still need another one to run...lol
BC: Thanks, do you know of where I could purchase the tabs and parts required to do the switch? Thanks
BC: Thanks, do you know of where I could purchase the tabs and parts required to do the switch? Thanks