The plug wires are new, along with cap, rotor, & plugs. I plan on removing the filter again this evening & pour it out in a jar, & I will also be checking the pick up tube with low air pressure, & soapy water. I hope to get a scan tool on it tomorrow, but I'm really not thinking it will turn up anything. I had someone suggest a possible injector problem, that is about the only thing in the fuel system I've not checked into.
Something I just thought of....I read on a thread a while back, about the routing of plug wires, & that they should not be in contact with each other. Well, mine are routed neatly thru separaters, but however, where they turn up to go to the cap, I have each side bundled together. Could that be a problem? Just thinking out loud here....
I do appreciate all the input here, hopefully I get this figured out soon. I really hope to put it up for sale so I can buy something a bit bigger.

That was the latest thing I replaced, pressure was way down, & the needle on the gauge was very eratic. I replaced the pump & all seemed to be good....Until....Problem started again.....