Part # for HP500 intake
 

Need to replace an intake on one of our engines. It is a stock HP500 EFI.

First, is there a GM part number where I can buy from GM??

Or if not what is Mercury's part # ??

Also does anyone know of any good used ones available??

I have a couple used ones.
Matt
903-786-3797
matt at dpmpower.us

It's a Dart intake with Merc blue paint. I believe it's NLA from Merc, but you can buy a new Dart for a whole lot less than the $1100+ that Merc had it listed for, and paint it Merc blue. I have the color code for the Merc blue paint.

I have one

$250 plus shipping

MINT condition

Hey Bill,
The Mercury part number is 849900T 3. If you dont buy one already painted I know you can get blue paint and clear coat to make it new again.

John

I have the sister to this intake sitting on my dining room table. It IS mint.

Hey Cuda,
Bill said it was an EFI intake.:D I bet the wife likes that! I know what my wife says when I bring tools into the house!:angry-smiley-055:

The lower is a GM part and the upper is Arizona Speed & Marine if my second-hand info serves me correct. It's possible the whole thing is AS&M. I've seen that Volvo and Marine Power have used that intake also FWIW.

Cuda, I don't that is gonna work:violent-smiley-045:

Hey Joe...That looks way too squeeky clean to me. Not to mention a stones throw from the dish washer.

Glad you all were able to catch on to the fact that I do need a EFI intake not carburated.

Thanks anyways Cuda:D:D

Oops, I didn't see the EFI part.

How much for the flowers?:rolleyes:

A dollar two ninety eight. :)

No body noticed the carb next to the dish drainer or the seawater pump also on the counter :D:D

Still looking for a EFI intake for a stock HP 500

I Have 2 Available 1 Complete With Injectors One Missing 4 Injectors
Call Me Toll Free To Discuss 877-419-6464 Marty Midwest Performance

43 Thunder,
I also have 2 availible... Off of my 2004 EFI's (64hrs) when Whipples were installed. Complete minus IAC motor,PCV,Intake air temp sensor and 2 coolant temp sensors.... All injectors are there and working.
Rob 910-524-5438 (Located in NC)

Can anyone confirm whether all the Merc units use a rectangle port lower manifold? I see AS&M offers both oval and rect port. So far it looks like the Volvo pieces are oval. Wonder if you could hog out the ovals a bit or whether it'd be worth it...

The Mercury part is rectangular port for the 500 EFI.:D

one on ebay
http://cgi.ebay.com/ebaymotors/Mercu...QQcmdZViewItem