roooster tails
#21
I see way too many folks with Bravos that are trying to be 'cool' and trim their boat to the moon for a rooster tail. There was someone doing it on a Poker Run last year in a 22' boat w/ a Bravo, and the boat was WAY out of control, and no one would go near him.
Not only are you going to break your U-joints, but you are going to find a little wave to launch off of at the perfect wrong time, and the boat is going to get way out of control and hurt someone, or worse.
Not advised.
If you want to throw some water around, drop your trim tabs all the way down.
Not only are you going to break your U-joints, but you are going to find a little wave to launch off of at the perfect wrong time, and the boat is going to get way out of control and hurt someone, or worse.
Not advised.
If you want to throw some water around, drop your trim tabs all the way down.
#22
Platinum Member
Platinum Member
From outside the rig...
[YOUTUBE]http://www.youtube.com/watch?v=L7u0LZvb-Hk[/YOUTUBE]
From inside the rig
[YOUTUBE]http://www.youtube.com/watch?v=IistcobzWh0[/YOUTUBE]
Hope this helps. Always glad to contribute!
#26
Registered
Turbines may give ya one too.
#29
Registered
iTrader: (1)
Tell him to buy a surface drive boat, so as not to tear up the ujoints.
http://video.google.com/videoplay?do...84901719480369
http://video.google.com/videoplay?do...75446095368010
http://video.google.com/videoplay?do...96774749998736
http://video.google.com/videoplay?do...84901719480369
http://video.google.com/videoplay?do...75446095368010
http://video.google.com/videoplay?do...96774749998736
What is the point of "looking cool" at the cost of breaking chit?! but hey... to each his own!