any thoughts on a 1999 merc 250EFI
12-12-2007 | 02:04 AM
#11
Registered
Joined: Dec 2000
Posts: 2,922
Likes: 5
From: Slightly North of Cuba
I know where there was a 30" shaft 2000 250. Under 300 hrs, guy is unreal anal about maintenance.. He went to twins on the boat. Controls, gauges included, I think he was asking 3500 or so....
12-12-2007 | 06:35 AM
#12
Thread Starter
Registered
Joined: Aug 2003
Posts: 7,392
Likes: 1
From: Boca Raton
If its the one I am thinking of, one burned up, and the other is on Ebay right now for 3700, this one is rebuilt with a short warranty for less$$
12-12-2007 | 08:31 AM
#14
Thread Starter
Registered
Joined: Aug 2003
Posts: 7,392
Likes: 1
From: Boca Raton
Hope so,
the 2.4 was a pig out of the hole, but kicked azz on the top end. I am sure I could have overcome the bad holeshot if I had enough time to set up properly before blowing it up. Everyone tells me the 3 liter has awesome low end torque, hope the top end throttle response is as good as the 2.4, it was amazing to give it a little throttle, and have it jump like that with just 200 HP. The other thing I am hoping is that with the actual alternator(60 amp I believe), I can now move the batteries up to the front for better weight transfer.
the 2.4 was a pig out of the hole, but kicked azz on the top end. I am sure I could have overcome the bad holeshot if I had enough time to set up properly before blowing it up. Everyone tells me the 3 liter has awesome low end torque, hope the top end throttle response is as good as the 2.4, it was amazing to give it a little throttle, and have it jump like that with just 200 HP. The other thing I am hoping is that with the actual alternator(60 amp I believe), I can now move the batteries up to the front for better weight transfer.
Thread
Thread Starter
Forum
Replies
Last Post
East Coast B
General Boating Discussion
18
02-04-2013 01:47 PM
NJgr8ful
General Boating Discussion
1
09-15-2005 02:38 PM
