C M I 's
#1
Registered
Thread Starter
Join Date: Mar 2001
Location: montauk new york. usa
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
C M I 's
What is the average lifespan of CMI headers from the mercury racing factory, installed on their 500 & 525 efi's ? Have any of you guys had them start leaking internally on you ? If so ,how many hours did you run them before they leaked ,and did their failure cost you more than a replacement set .......................(ie, valves,heads ,ect. ).I've heard a few different stories ,would like to hear yours
#3
Registered
Thread Starter
Join Date: Mar 2001
Location: montauk new york. usa
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
Are they just as bad ? or do they have a better track record ,I'm looking at a boat with 500 efi's and 287 hours ,was wondering how much longer I can expect to get out of them ,and will I know when to change them before anything else gets damaged from them leaking ??????????????????????
#6
Platinum Member
Platinum Member
Join Date: Aug 2001
Location: Sarasota,FL & Saugatuck, MI
Posts: 1,060
Likes: 0
Received 23 Likes
on
6 Posts
Mine in a 382 with 500EFI's lasted for about 200 hours. Then needed complete engine rebuilds due to leaks into the heads. And that was even with regular fresh-water flushing.
Oh: needed new headers and tail-pipes, too.
The original Silent-Choice lasted even fewer hours.
Salt kills!
Oh: needed new headers and tail-pipes, too.
The original Silent-Choice lasted even fewer hours.
Salt kills!
#10
Registered
Join Date: Apr 2004
Location: Lake Orion Michigan
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Header leaks
They cost me a motor . Droped a valve cracked the block. I sent both to cmi to pressure test & repair they said the starboard was junk and they would'nt warranty it . They said Mercury specs were different than there own (thinner & cheaper materals used) the port is perfect may have been replaced before. I tryed to have the best welder in the state repair it after 6 atempts he gave up. I would like to find a good starbord header only, if any one has one or wants to buy my port header and tail pieces. they are in great condition. I am putting keith ekrert on the new motor.248-933-5595 [email protected]