Bustd GIL Manifold.....what to do!?!?
#1
Registered
Thread Starter
Join Date: Aug 2010
Location: Seaford, DE
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
Bustd GIL Manifold.....what to do!?!?
I have a pair of HP500's. One motor has a bad set of manifolds. All ive seen is Hardin makes a replacement for like 2500 bucks.
Do i have any other options? These are the wet Gil's btw.
Thanks
Do i have any other options? These are the wet Gil's btw.
Thanks
#8
Charter Member # 55
Charter Member
Chances are, if one of the Gil manifolds is bad, then the others are not far behind.
If you boat in salt, then I would look at Stainless Marine. If fresh water, then I would probably lean toward CMI's.
If you boat in salt, then I would look at Stainless Marine. If fresh water, then I would probably lean toward CMI's.
#9
Registered
Join Date: Dec 2010
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
I agree with the stainless marine manifolds.Have used on many boats in the past great products and work well. Be carful with CMI very expensive and will leak, the leaks are not there fault just 2 tubes at differant temperature breaks weld at collecter