But that just has one engine.....I won't know what to do with that few wires!!! :)

Got 1 panel left to put in when it gets here next week so no finished pics.......but here some of what I had to work with.

more.....

Spend an xtra hour or so dressing those wires so they look perfect and not a rats nest......you will appreciate it later! Looking good!

Got the final panel in from Innotech Products right before Christmas......and now the dash is finished. Unfortunately I had to take these pictures inside and after dark.

The panels are vibrant red and look great......need some daylight photos.

If anyone is looking for something like this give Steve a call. He was really easy to work with and did a great job for less than I was expecting.

Steve at Innotech Products
[email protected]
314-432-1900

that looks nice how did you do your latch and military rockers?

Military rockers? Are you talking about the drive and tab switches. Steve had never done one like mine/ours with the threaded studs on the back of the panels. He made one of me that would have worked if my panel was more recessed. I told him I'd like it made thinner for a better fit and he was willing to try it again for me......the second worked great.

The latch was another issue. I gave Steve the spec's for the two studs but I missed measured something. I ended up cutting off what he made and then cut off the entire stud/bracket off the factory main dash panel the re-use. I mounted the main dash panel without any gauges installed and reached through the tach holes to hold the old mounting bracket while some 5 min epoxy dried long enough to stay put......once that was dry I installed everything in the panels and the back into the boat.

Looking at an install soon? :)

Very, very nice! I have those carbon fiber panels on my AT, in blue. Definitely get some photos in the sun to really show them off.

Nice Russ:ernaehrung004: