New dash for a Formula 382
#23
Registered
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
#24
21 and 42 footers
Platinum Member
Thread Starter
Got the final panel in from Innotech Products right before Christmas......and now the dash is finished. Unfortunately I had to take these pictures inside and after dark.
#25
21 and 42 footers
Platinum Member
Thread Starter
The panels are vibrant red and look great......need some daylight photos.
If anyone is looking for something like this give Steve a call. He was really easy to work with and did a great job for less than I was expecting.
Steve at Innotech Products
[email protected]
314-432-1900
If anyone is looking for something like this give Steve a call. He was really easy to work with and did a great job for less than I was expecting.
Steve at Innotech Products
[email protected]
314-432-1900
#27
21 and 42 footers
Platinum Member
Thread Starter
Military rockers? Are you talking about the drive and tab switches. Steve had never done one like mine/ours with the threaded studs on the back of the panels. He made one of me that would have worked if my panel was more recessed. I told him I'd like it made thinner for a better fit and he was willing to try it again for me......the second worked great.
The latch was another issue. I gave Steve the spec's for the two studs but I missed measured something. I ended up cutting off what he made and then cut off the entire stud/bracket off the factory main dash panel the re-use. I mounted the main dash panel without any gauges installed and reached through the tach holes to hold the old mounting bracket while some 5 min epoxy dried long enough to stay put......once that was dry I installed everything in the panels and the back into the boat.
Looking at an install soon?
The latch was another issue. I gave Steve the spec's for the two studs but I missed measured something. I ended up cutting off what he made and then cut off the entire stud/bracket off the factory main dash panel the re-use. I mounted the main dash panel without any gauges installed and reached through the tach holes to hold the old mounting bracket while some 5 min epoxy dried long enough to stay put......once that was dry I installed everything in the panels and the back into the boat.
Looking at an install soon?