carbon fiber dash panels
 

Just wanted to share with everyone....just got my carbon fiber dash panels back from tecnografic in Ft Laurderdale Fl


They did an amazing job!!!!


here's there info contact Marc

http://tecnografic.com/

SaaaweeeeeT!! :cool:

If you dont mind my asking, whatd it run you to get those done? They look really thick. Is it a true CF or is it an overlay on top of fiberglass?

Very nice. I just got off the phone with them. Re-fitting the Talon....this will look great.

That looks real good!

I re-did mine in Dec and had Innotech Products do mine. Looks like the same kind of work and I was real happy with my final pieces too. Looks great.

For the do-it-yourselfer...http://compositeenvisions.com/rigid-...iber-panels-1/

COOL!! I told them I would post picts and they should hook us up so good luck. Just be patient it took about a month or more but worth it.

Now
for the guages

Thanks they are true carbon fiber what looks to be epoxied to black plexi.

I know when I called last week to check on the process they told me they were "curing"

All of the panels were 870.00

Of course I made the templates which took at least three fittings, and then since I am building from scratch I had to figure out where I wanted the guages, pre fit and then I had to pre drill everything.

They turned out absolutely perfect

Thanks bro......now :signs069: on my graphics

in addition to what I sent you I want to do a small emblem for the dash, got to figure this out later after I drill the switches and put GPS in.

keep in touch!!

Carbon Dash Panels
 

I had set done for my 47 Fountain from Steve at Innotech Products came out Incredible. They make all the Carbon Panels for all the new manufacturers MTI, Nortech, Donzi, Cigarette, Fountain etc. turnaround was quick about two weeks. Will post Photos soon

www.innotechproducts.com

thats great info...... a little late though