bolster issue
03-16-2009, 09:10 PM
#1
Registered
Thread Starter
Join Date: Oct 2001
Location: Tampa,Fl.
Posts: 1,124
Likes: 0
Received 0 Likes
on
0 Posts
bolster issue
just had 3 screws with washer and looks to be a jagged anchor on tip fall to the floor yesterday. These are drop down elec. bolsters. What would be the quick fix not to mention the cheapest without pulling the poly-board out and replacing with new? I have some ideas, but want to hear from others that had this issue.
03-18-2009, 06:39 PM
#2
Guest
Posts: n/a
If you post a picture of the area , we can advise you the best way to fix this . Since we've probably ran across just about every possible problem that is possible to have with bolster seats and frames, or e-mail me directly [email protected]
