|
drive cylinder stops
Since I added extension boxes my drive tie bar is hitting the swim platform at 7 on the indicator when I raise the drives. Do they make a drive cylinder stop so I can alliminate this glitch so the drives will stop before hitting the platform?
|
Call Marc Berman at BAM Marine
|
Maybe I'm way off here, but can't you just adjust your limit switch on the drives? Just loosen the screws and twist the switch, after adjusting, tighten screws again.
http://www.sterndrives.com/supplies/trim_limit_port.jpg |
Item # 27 in this pic, goes inside the cylinder to limit
cylinder up travel. http://www.mercruiserparts.com/Show_...ydraulic+Hoses |
Originally Posted by Chico&Zeus
(Post 2843725)
Maybe I'm way off here, but can't you just adjust your limit switch on the drives? Just loosen the screws and twist the switch, after adjusting, tighten screws again.
http://www.sterndrives.com/supplies/trim_limit_port.jpg |
| All times are GMT -5. The time now is 05:11 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.