Break-in oil for rebuilt motor
05-26-2009, 12:47 PM
#11
VIP Member
At Raylar Engine we like to use Shell Rotella 15-40W for breakins, got a great zinc and additive ashless wear package and after breakin you can switch to synthetics. I also like the gallon bottles, pouring 10 quarts from quart bottles just sucks!
Best Regards,
Ray @ Raylar
Best Regards,
Ray @ Raylar
The last 3 rebuilds I have used the cheap Napa straight 40 for break in, its only in there maybe about 1 hour, 5 dyno pulls or until I put a good load on it to seat the rings.Rob
__________________
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
.
The Only Time You Have To Much Ammo Is When Your Swimming Or On Fire.
05-26-2009, 12:48 PM
#12
Registered
What about break in on a NEW long block? Rotella still OK? What about a straight HD40?
05-26-2009, 11:51 PM
#13
Registered
Join Date: Jan 2004
Location: San Diego, California
Posts: 2,777
Likes: 0
Received 6 Likes
on
6 Posts
I would use the Rotella and change it and the filter between 5 and 10 hours. Also carefully cut open the filter that is removed and spread the pleated media inside and look for debris, especially iron, steel and aluminum particles. If there is a lot, check the oil filter again within a couple of hours of use and make sure the debris stops.
Best Regards,
Ray @ Raylar
Best Regards,
Ray @ Raylar
Platinum Member
