Prop Lost And Found
Can anyone help a brother out?
We lost a prop out on Narragansett Bay. The Mcloud Prop lock backed right off. This is the second incident with these locks please be advise. Anyone have any leads on one right hand 37.5P 5 blade Herring? Please call Gerry Thanks in Advance 508-399-6440 |
I would cry if I lost a Herring.....
|
Originally Posted by seafordguy
(Post 2933185)
I would cry if I lost a Herring.....
I called Randy at Cobra he may have one lined up. |
We might have one, what is the pitch? 17 1/2 x ??
|
Originally Posted by animalhouse
(Post 2933316)
We might have one, what is the pitch? 17 1/2 x ??
I can have anything close worked on. Thanks Fred Paul drove right by the Borden Light Marina Saturday. Thought he was going to join us. |
He went to Long Island, Mike saw the guys running in and ran with a few of them for a while, we would have loved to do the run, but had a scheduling problem with some customers coming in.
I will give you a call after I check out the stock room. |
Originally Posted by animalhouse
(Post 2933421)
He went to Long Island, Mike saw the guys running in and ran with a few of them for a while, we would have loved to do the run, but had a scheduling problem with some customers coming in.
I will give you a call after I check out the stock room. This is one of the Perks of having a HiGHLINE Boat builder in your backyard. Thanks Fred! |
Anyone ever drill the very end of the 6 Shaft and install a cotter pin?
HEY JC PERFORMANCE any of you long Island boys got any Props laying around??????? |
Woudl probably just shear off the cotter pin once the nut loosened up. What about double nutting?
|
Originally Posted by Audiofn
(Post 2933964)
Woudl probably just shear off the cotter pin once the nut loosened up. What about double nutting?
Yes Good suggestion What I may try is use factory nut. Then back down the locks to that. Pete Nopper just got off the phone with Mercury HP They require 100ftlbs. The problem with the 6 locks is once you continue to reuse them the Key does not grab it properly allowing the proper torque. This is what cost me the prop:eek: |
All times are GMT -5. The time now is 07:19 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.