OT: Anyone in the Plastic Supply Industry??
I have been looking around the net with out much luck, so i figured i post here since i usually get answers quicker though you guys/girls :).
I am looking for a Low Density Polyethelyne material in multiple colors (black,red,blue,grey,yellow). The reason for that particular Poly is only because of the high impact, and easy machinability properties (and the low cost - as compared to nylon). I need 1" thick plates. If anyone knows where to find this material in colors, or knows of a similar material that does come in colors, Holler Back!! Thanks |
did you look at Kingplastics.com ? i was browsing around there the other day . they may be able to help you
|
I talked to KingPlastics. They told me it can come in colors, but it has to be purchased in large minimum qauntities...and they only sell to distributers.
I buy my plastic through McMaster-Carr, who uses KingPlastics. King told me to ask McMaster if they carry colored Poly...they don't. :rolleyes: |
|
Try this place- I have purchased small quantities of plastic from them.
http://www.machinist-materials.com/ |
thanks guys....i'll check them out. Anyone else??
|
Try Ben Benvenuti @ Commercial Plastics - (813) 248-4212.
Tell him that his attorney, Bryan, recommended you call... he may be able to help - deals alot in surplus, spec, off-spec and recycled materials. |
Try General Electrics polymerland. Not sure on the address.
|
Mark -
Call Ben Benvenuit @ Commerical Plastics again - your voice mail message was garbled.... he may be able to help you. - Bryan |
Thanks Bryan......I just called him back (4:45) and he's already left for the day. I try him again tommorow. I appriciate your help.
Mark |
All times are GMT -5. The time now is 03:48 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.