drilling low water pick up on a outboard
#2
Gold Member
Gold Member
Never heard of somebody simply drilling a set of holes in the standard gear case to make a low water pickup. I have the CLE gear case with the low water pickups built in, and there's a whole lot more to it than simply a set of holes. There are actually a set of removable (to clean out weeds) plates on each side just below the cavitation plate too. I'm not even sure if those passages exist in the standard gear case.
On a related note, most aftermarket nose cones that include a low water pickup include a set of external braided hoses to get the water from below the bullet up to near the old (standard) pickup point.
On a related note, most aftermarket nose cones that include a low water pickup include a set of external braided hoses to get the water from below the bullet up to near the old (standard) pickup point.
#3
Registered
Thread Starter
Join Date: Apr 2003
Location: Punta Gorda
Posts: 1,838
Likes: 0
Received 0 Likes
on
0 Posts
This is on a 1995 225. I have a 30 concept that 1 eng idles fine get on plain and it over heats. Looked at the lower one has duel pickups and the one that runs hot only has the ones on the side. Its sucking air.
#4
Platinum Member
Platinum Member
Join Date: Jun 2001
Location: Silverdale,Washington,USA
Posts: 602
Received 0 Likes
on
0 Posts
As Too Stroked has said you can't just drill the holes in the front of the gearcase, there are no passages up to the waterpump. There is one thing you can try, that is you can plug the upper holes on the side of the gearcase, 2 or 3 on each side so that it won't suck air. You can either fill them with epoxy or drill and tap the holes so you can locktite an allen head setscrew in the hole. If you truely need a low water pickup you would have to add a nose cone to the existing unit.
#5
Gold Member
Gold Member
As Too Stroked has said you can't just drill the holes in the front of the gearcase, there are no passages up to the waterpump. There is one thing you can try, that is you can plug the upper holes on the side of the gearcase, 2 or 3 on each side so that it won't suck air. You can either fill them with epoxy or drill and tap the holes so you can locktite an allen head setscrew in the hole. If you truely need a low water pickup you would have to add a nose cone to the existing unit.
#9
Registered
Join Date: Apr 2004
Location: maryland
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
I dont know if this would apply to a newer merc outboard,but 35 years ago ,when we were all running hydrostreams and checkmate outboards a lot of the mercury outboards were overheating due to raising them4 to 8 inches .
We came up with a simple solution by installing a small scoop over pickup holes and waterpressure picked right up and solved the overheating issue.
We came up with a simple solution by installing a small scoop over pickup holes and waterpressure picked right up and solved the overheating issue.
#10
No Comment
VIP Member
Join Date: Jan 2002
Location: This post copyright, Packinair Inc. All rights reserved.
Posts: 1,622
Likes: 0
Received 0 Likes
on
0 Posts
on my cat for awhile I was having water issues and had low water pick ups on the sponsons and a hose that went up to between the mid and powerhead. worked great
__________________