#6 Rebuild
 

How much should a #6 Drive Full rebuild cost??? The cases are good however all gears, Prop shaft and seals need to be replaced.... Any feedback would be helpful....

About 5k for what you need, call Vern at West Coast Drive Service, Lake Havasu City, Az (928) 846-4478

Call TNT in Miami. Matt can get you fixed up.

give Randy at Marine Drive in St Mary Fl a call 352-257-2186

5 grand would be a gift.

Ocean, Thanks for the reply but do you really think I can get them rebuilt for 5k Each???? My Bravos cost almost that much...

No. I think that he forgot to factor in the price of the gears and propshafts. :cool:

You would be better of financially to buy some used ones and have them gone through. ;):)

Used could be the same or even worse from what he has now.

Go brand new... 30k a pair???

I'll second that........

I send my #6's to Craig Colabella of Colabella Performance in St Cloud, FL. Craig used to work for Lake X and his job was to work on the #6 drives among other things. Matt at TNT in Miami is also a top notch drive man. Craig charges $1,000 to tear down and rebuild a #6. Prop shafts are about $1,800 each. Lower gear sets are close to that as well. If you need upper gears add another 2 grand per drive. All seals, propshaft bearings, split line o-rings, drive oil, etc run about $350 per drive. Assuming you have a twin engine application and you are refreshing both drives, you can often swap the lower gears from one drive to the other as they only wear on one side. That saves about $1,800 a drive. If you need to overhaul the whole drive of all parts, figure $7,000+ per drive. If you need just seals, etc (no gears or propshafts) figure $1,350 per drive.