What he has will work but you need to turn the diodes around. The line indicates the end with cathode.
|
Originally Posted by Double Rigged
(Post 3311037)
What he has will work but you need to turn the diodes around. The line indicates the end with cathode.
|
A 6 amp diode is the biggest common one with wire leads, like the General Instrument p/n GI 751, GI 752, GI 754, GI 756 ... as the number go's up, the max voltage you can use it at increases, so for 12 or 24 volt circuits the PRV (peek reverse voltage) of 200 or more is appropriate, as there are voltage spikes in the system from any inductive loads, such as starter motors, solenoids, and such.
The diode is like a check valve, passing current when the stripe or cathode end is closer to the more negative side of the circuit. (the diagram has them backwards) notice the far side of the lamp is connected to negative. in the circuit the switch that is on will pass current through the first diode, but the other will not pass it to the second circuit. I hope this is a help. Mike |
All times are GMT -5. The time now is 09:04 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.