anyone have a dyno that will handle high hp?
02-13-2011, 09:41 AM
#41
Registered
Thread Starter
here is a pic of what i mean by polishing..
here is a pic of the side of my engine block and the back of the engine block.. notice the big block bell housing bolt patten on the back..
here is a pic of the side of my engine block and the back of the engine block.. notice the big block bell housing bolt patten on the back..
02-13-2011, 10:55 AM
#42
Platinum Member
Platinum Member
Tyson,
Did you check with Kieth Eickert and the new set up he has in Chicago?
Seems it was set up very well also............
Good luck with your project and continued innovation!
Jon
Did you check with Kieth Eickert and the new set up he has in Chicago?
Seems it was set up very well also............
Good luck with your project and continued innovation!
Jon
