anyone have a dyno that will handle high hp?
 

we have a new engine that we can only tune the low hp stuff up to around 1800, and we need to find someone with a dyno that will handle alot more to tune it when we turn the boost up.

anyone have a dyno with dual water brakes?
anyone have anything with a very large water supply so we can do constant load testing for long time? minuites? hours? with out boiling the water?

Tyson

We have had 3500 ft. lbs on our dyno.

Check with Mark at Precision Marine.

www.pmefi.com

We have 1000 gallons in reserve and 2000 hp + brake dual rotor Supply pump too big it had to be regulated down.
Come and take a look or call, plus we are not that far.
Jim
573 346 5250
www.ozarkspeedandmarine.com

I was about to post up Jim but you beat me.:angry-smiley-038:

Also we can run our full wet cmi's with 8 egt's and o2 sensor :coolcowboy:
Have adapter to run dual cooler rear mount starter as well.
Thanks
Jim W.

Those motors look bad ass

Mark at Precision runs 2 diesel truck engine brakes. I'm sure he can handle the power.

Running for minutes or hours is the deal killer with most dynos. That is a lot of water and cooling capacity! It would be difficult to keep the absorber water cool, let alone the engine coolant. I'm not saying it can't be done, its just a big under taking.

Dyno
 

Couple pictures of Dyno with 1075 Merc with marine set up.
Short video on facebook or in Skater section.