best valve covers for roller rockers 502 Mag
#1
Registered
Thread Starter
best valve covers for roller rockers 502 Mag
Putting roller rockers on my 1992 502 mag motor.Stock valve covers dont fit.Any advise on what to use from Merc, don't want to go aftermarket.
#2
Registered
Join Date: Dec 2000
Location: EASTON MA.
Posts: 6,281
Likes: 0
Received 0 Likes
on
0 Posts
aftermarket has some nice stuff, but I used a pair of older merc 540 500hp bulldog covers once. bill at Diamond marine [302 521 0123] has some nice prices and lots of covers. polished or in colors. good luck
#3
Registered
You may be able to use your stockers if you grind out the little titties on the under side of the cover. You will also have to remove the baffle. You may have a problem with oil wanting to come out of the pcv grommet.
CP Performance has some nice cast aluminum covers that are pretty reasonable. Here ya go.
http://www.cpperformance.com/p-13494...-oil-plug.aspx
Eddie
#4
Charter Member # 55
Charter Member
As Eddie said, stock valve covers will fit with slight modifications. All you need to do is grind off the oil drip tabs on the underside of the valve covers. Depending on which rocker arms you use, you may have to either modify the baffle or grind off a 1/4" of the corners on the #1 and #7 intake rocker arms. That is what Merc did on 525SC's and HP500's. The new Crane Golds should fit without any mods to the baffle or grinding the corners.
#5
Registered
As they said above plus... Mr. Gasket Makes an extra thick VC gasket.
I bought a couple cheap chrome sets from Summit for like 30 bucks a pair and had no drippers to grind off. I'm both cheap and lazy
I bought a couple cheap chrome sets from Summit for like 30 bucks a pair and had no drippers to grind off. I'm both cheap and lazy