Jcperf
#1
Registered
Thread Starter
Join Date: Oct 2005
Location: LI, New York
Posts: 1,491
Likes: 0
Received 0 Likes
on
0 Posts
Jcperf
Turned it to 5300 with a 32P, a full tank of gas, and 3 people. Need to prop it down.Jeff can still throttle. Turn up the volume.
http://youtu.be/Fdp1bcbC6bQ?hd=1
http://youtu.be/Fdp1bcbC6bQ?hd=1
#5
JC Performance Engines
Gold Member
Great 1st run.
Are you happy with the speeds?
Btw, does anyone make a bluetooth mic?
That would be slick to have it mounted to the transom.
The audio would be that much better.
Are you happy with the speeds?
Btw, does anyone make a bluetooth mic?
That would be slick to have it mounted to the transom.
The audio would be that much better.
#7
Registered
Thread Starter
Join Date: Oct 2005
Location: LI, New York
Posts: 1,491
Likes: 0
Received 0 Likes
on
0 Posts
SV43BB,
Saw your 1075's at the shop today. Looking forward to seeing what it'll do.
#8
Registered
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
Sounds aweome and ran good for a couple minutes!! Not sure what you mean though about "not many engine builders are as honest, forthright, and straight forward". How many engine builders have you tried? Teague? Zul? Pfaff?
#9
Registered
Join Date: Nov 2003
Location: Little Silver,NJ
Posts: 302
Likes: 0
Received 0 Likes
on
0 Posts
[QUOTE=Mastercraft240;3397501] Jeff has gone over and beyond with me and this motor. I can truthfully say not many engine builders are as honest, forthright, and straight forward.
I second that he always goes above & beyond & w Zul doing the setup on the dyno Jeff is hard to beat for the price. I do think he weighs more than 190 lbs though !
I second that he always goes above & beyond & w Zul doing the setup on the dyno Jeff is hard to beat for the price. I do think he weighs more than 190 lbs though !