twin engine kill switch
 

does anybody make a kill switch that controls both engine?

Yes Mercury.

cp performance has one

Couldn't you just wire both through a single switch?

Mine is wired through a single switch. I got a nice looking billet one to match my guage bezels. Could have been livorsi.

I have a brand new one. dont have the lanyard. $25 plus the shipping and it is yours if you need it.
steve

Thats how mine was set up from the factory.

Fountain sells on for about $35 including the lanyard. I think it is a double pole single throw switch because it has two identical sets of wires coming out of it, one for each engine.

I checked cp they only have one listed for a single engine how do i get a hold of fountain?

I did 2 and just tied the two lanyards together.
There is nothing that both motors use together that way there will never be both motors down because of one part.

Your boat doesnt have one?????

No it does nt 83 formula i re did the whole boat and there was nt one there from the factory. I just ordered the one from cp thanks guys

How is a switch wired in on new installation? Off ignition switches?

Ill post up when i get mine and tell ya. Cp says its one switch with 2 curcuits.

it does..

this is a old thread I started a couple of boats ago

This is the one I have on mine, works great, easy to wire.

other options for billet,,http://www.danamarineproducts.com/KillSwitches.htm

This is the one I have on mine, works great, easy to wire.

other options for billet,,http://www.danamarineproducts.com/KillSwitches.htm

whoops. Didn't catch that.

Bringing this old thread back up again.

My twin outboard Skater has 2 Mercury Racing kill switches:

https://www.cpperformance.com/c-175-kill-switches.aspx

The starboard kill switch kills both engines. The port kill switch kills the port engine only. That does not seem right. How are these supposed to be wired?
__PRESENT