Bravo spacers
anyone have a pair of 1" or 1 1/2" spacers they want to get rid of that will fit a bravo X drive?
Thanks |
I have one 1" that has a hour of test time on it
|
I also have (2)1" Bravo spacers that need to go, only one will fit a normal Bravo, the other is machined to fit over the special Max Machine worx full tower so Pm me if you need one, Smitty
They both have less than a hour test time |
I have a pair of 2" spacers that you could machine down.
|
I have a pair of 1" I used on my XRs, make an offer
Shawn |
Originally Posted by bobkatz
(Post 3502792)
I have a pair of 2" spacers that you could machine down.
I sent a pm to everyone else who replied. Thanks. |
I've got some 1.5" that I will sell.
|
Originally Posted by SkiDoc
(Post 3503408)
I've got some 1.5" that I will sell.
|
Originally Posted by SkiDoc
(Post 3503408)
I've got some 1.5" that I will sell.
|
So i measured the boat and the bottom of my cavitation plates are 1 7/8" above the bottom of the chine directly in front of the drive. I think that a 1 1/2" spacer will be the right one for as 2" will be to low and 1" won't get me low enough. anyone have any suggestions? Still looking for a set of 1 1/2" spacers.
http://i272.photobucket.com/albums/j...i/DSC_6494.jpg |
All times are GMT -5. The time now is 03:46 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.