III Speedmaster props
I have a #III drive 19 spline with the longer prop shaft. The hubs on the props that are on it are 6"s. Is there a way to get the 4" hub props on it?
|
I think arenson makes adaptors for it. They are not cheap if I remember correctly like 400 each.
|
I've seen some guys run spacers between the prop nut and the back of the prop so they could run the short hub props on a long hub shaft, don't know who makes them but you could probably have a machine shop make something.
|
Originally Posted by J. Hordubay
(Post 3580517)
I've seen some guys run spacers between the prop nut and the back of the prop so they could run the short hub props on a long hub shaft, don't know who makes them but you could probably have a machine shop make something.
It should be pretty simple to build a couple spacers. |
Artie, you volunteering, LOL
|
Originally Posted by bigboat28
(Post 3580952)
Artie, you volunteering, LOL
Anybody have dimensions? What material to use? Bronze? |
Shouldn't we be able to just make a spacer to go between the nut and the prop? What does the thrust washer look like? Been a while since I've payed any attention to a SSM...
|
My buddy had a setup like that. Short hub prop, made a spacer.
|
All times are GMT -5. The time now is 07:33 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.