Thats what He needs. Just thought He could adjust till He found it.

AKA, something like this:

Thats what I was thinking. Thanks for the pic. Artie

That doesn't work to put the bow eye below the bump stop - i've tried it. The problem you then get is the front of the bow comes in and will run into the flat stock BELOW the bump stop.

Going to a poker run in two weeks and the ramp I launch at is REAL steep. I need the one that 78 CIG posted - that's what I used to have on my Manning, but I don't have it on this trailer.

A local place will fab it for me next week, just was hoping that someone had one they wanted to sell and I'd go that route instead.

If you were in fl I would build you one.

Click here and scroll down to bow stops. I bought one of the V style from these guys and couldt be happier.
http://www.loadmastertrailerco.com/options2/

Fabbing one up wouldn't be to bad, I haven't been able to find the rubber D blocks

Did they sell you just the "slip-in" section shown circled in yellow below? If so how much did they charge for that?

Thanks in advance,

Dave

http://lh5.googleusercontent.com/-rM...rformance2.JPG

The only pic I have but I bought the part you circled and the part it slides into in galvanized steel. It came with stainless hardware to ubolt it to the frame. Very nice people to work with.
This is the only pic I have. This type of bow stop is almost a necessity on a beak boat.
http://img.photobucket.com/albums/v3...g/Cover005.jpg

Thanks! That is exactly what I need. I'll call them Monday.

Did they make yours in aluminum? Do you remember how much it set you back?