Offshoreonly.com
Page 3 of 3
1
2
3
Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Boating Discussion (https://www.offshoreonly.com/forums/general-boating-discussion-51/)
-   -   Shark bite at lotto (https://www.offshoreonly.com/forums/general-boating-discussion/302334-shark-bite-lotto.html)

thumper038 09-06-2013 10:25 AM
Originally Posted by NASCAT (Post 3987400)
I worry less about heat & warping & more about welding your gearset together, unless you plan to totally disassemble. Have to be careful b/c you are grounded to the lower itself so all the energy is passing thru the entire lower.

I have welded many skegs and # 6 Skegs
Keep the ground path close to the weld are and keep the circuit small so as not to travel into the unit or even through the boat to electronics if still on boat , always a good idea to disconnect.
Weld small and keep cool as others have said. Step the repair for larger damage.
Jim


All times are GMT -5. The time now is 01:49 PM.
Page 3 of 3
1
2
3
Show 40 post(s) from this thread on one page


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.