Mitcher T Painting the first Donzi ZRC
#1
Registered
Thread Starter
Mitcher T Painting the first Donzi ZRC
Mitch is finishing up painting his design on Steve Simon's creation. This was the very first Donzi ZRC out of the mold back in 2002 and it bears the hull number 001. This is the boat that Steve Simon designed to get Donzi back into racing. They took it to the Miami boat show in 2003 and the fist person who took a test ride in it bought it on the spot - the owner of the Harley Davidson dealership in Daytona Fl. It initially served as the APBA pace boat for many races and was then sold to an OSO member who used it on LOA. It was then sold to another member here on OSO up in Baltimore who in turn sold it to me back in 2011 without power or drives.
It was showing a lot of wear by the time I bought it and it's been long process having it refurbished but I am finally seeing some light at the end of the tunnel . Here are some before Mitcher T pics. The first pics are from when it was new back around 2003 and then some more around the time I purchased it in 2011. If it had looked as good when I purchased it as it did in these old pics I would have probably kept it original.
Jerry Haney is doing the rigging. The boat was originally a side-by-side set up with Merc 500's and bravo's and Jerry converted it to staggered with Arneson ASD-7s.
It was showing a lot of wear by the time I bought it and it's been long process having it refurbished but I am finally seeing some light at the end of the tunnel . Here are some before Mitcher T pics. The first pics are from when it was new back around 2003 and then some more around the time I purchased it in 2011. If it had looked as good when I purchased it as it did in these old pics I would have probably kept it original.
Jerry Haney is doing the rigging. The boat was originally a side-by-side set up with Merc 500's and bravo's and Jerry converted it to staggered with Arneson ASD-7s.
Last edited by Marginmn; 10-11-2013 at 04:30 PM.
#6
Registered
Thread Starter
The red bilge was a swing and a miss. New carbon fiber interior and dash panels. Later on we also switched the red side panels to the gray carbon fiber as the red panels clashed. Then late summer it was sent to Mitch to redo the bilge and for a complete paint job.
Last edited by Marginmn; 10-11-2013 at 03:14 PM.
#8
Registered
Thread Starter
That would be cool. Mitch hopes to be done with it next week and then it goes back to Jerry Haney in NC for the rigging. Jerry is busy getting that SVL boat ready for KW so as soon as that is completed he'll be back on the ZRC.