|
4.5 inch turndowns needed with an 8 inch drop.
Where to buy?
|
No one has a suggestion???
|
Turndown 4 what?
|
Exhaust turndowns to put the exhaust into the water instead of adding mufflers. I have dry headers and want to quiet it when off plane.
|
|
Looks like CLA caught my joke lol
Tink Tink try Teague they should have what you need. Gibson and others make 'em |
Tink Tink was a joke too but can't post the video from my phone
|
Originally Posted by fantastixvoyage
(Post 4119895)
Looks like CLA caught my joke lol
Tink Tink try Teague they should have what you need. Gibson and others make 'em |
You don`t want that donkey dick on your boat dude. if its too loud you`re too old. :D
|
Hey - I LIKE it loud but I would like to take the boat where they frown on loud noisy boats.
When you are taking it off the trailer with a cold engine I have to run it at 2500 RPM for at least 30 seconds before it will idle. Have heard thank you's from people when I shut it off. You know it is loud when performance boaters say that. At Hardy the sheriff told me " nice boat ". |
Originally Posted by fantastixvoyage
(Post 4119857)
Turndown 4 what?
|
Ha! I hear ya, its nice to hold a conversation coming back to the dock without yelling at each other.
|
Does anyone make these to order - or is there anyone in west Michigan that makes tails. It looks like the ones advertised are 90* Because I have dry tails that don't exit the transom at 90* I need ones that are between 45 and 60*.
|
Seems like you could find an exhaust shop that has a mandrel bender and make your own then polish. Slightly expand one end and slit it. Weld on bolt tabs to clamp it.
|
Go see Ben he makes all the time for the spring lake and GH hot rods.
|
Any big rigg exhaust shop can make . They have the 90's in stock and also the spreader to make them slip on .
RG. |
Do you have Ben's number and address?
|
|
poor little tink tink...... Lmao that dude is funny
|
Originally Posted by fantastixvoyage
(Post 4119899)
Tink Tink was a joke too but can't post the video from my phone
|
I had GGB make a custom set for me a few years back... http://ggb.ca/
http://i130.photobucket.com/albums/p...e/P1020875.jpg http://i130.photobucket.com/albums/p...e/P1020874.jpg Doug |
^^^^ now that's funny. Thanks for sharing.
|
Originally Posted by CLA
(Post 4119905)
All these dudes are serious around here bro! It's all about safety, drivers courses, F950's for a 27 fountain, and center consoles!
|
|
Is there anything special about the turndowns? Are they just hollow? And do you need a flapper on them if you already have the internal flapper in the exhaust system?
|
| All times are GMT -5. The time now is 06:48 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.