Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Boating Discussion (https://www.offshoreonly.com/forums/general-boating-discussion-51/)
-   -   When did your engine blow? (https://www.offshoreonly.com/forums/general-boating-discussion/323675-when-did-your-engine-blow.html)

ICDEDPPL 03-04-2015 08:47 AM

When did your engine blow?
 
Be interesting to see at what RPM (peak tq, or peak hp) motors take a dump.

seafordguy 03-04-2015 08:56 AM

No option of "when it filled up with salt water"???

Tom A. 03-04-2015 09:00 AM

Had them blow at both cruising and WOT. Depends on the situation.

WOT - Tired and abused internals - Long story

Cruising - Bad fuel

On a side note, the drives went at peak torque or idle! LOL

Tom A. 03-04-2015 09:01 AM


Originally Posted by seafordguy (Post 4273715)
No option of "when it filled up with salt water"???

Is that similar to oil pan failure? - That's when the pieces parts blow out the bottom and the oil pan fails to keep them in play.

Sydwayz 03-04-2015 09:09 AM


Originally Posted by Tom A. (Post 4273717)
Is that similar to oil pan failure? - That's when the pieces parts blow out the bottom and the oil pan fails to keep them in play.

I always liked the no spark problem:
Piston came up and knocked the spark plug out.

SB 03-04-2015 09:11 AM


Originally Posted by ICDEDPPL (Post 4273710)
Be interesting to see at what RPM (peak tq, or peak hp) motors take a dump.

Usually a lap or two (or run or two)after the announcer jinx's you by calling you out and announcing " XXXX has some sort of motor in that thing today !"

LOL.

88Fount33 03-04-2015 09:33 AM

Built 406 small block at 6500 pre-ignition timing took out a piston (#8), top ring chunks pushed into soft aluminum head. Ran it back to house at fast idle, beating and banging as I was on a lake without tow service one late afternoon during the week and NO ONE was on the water. About 2 miles away.

HyFive578 03-04-2015 09:42 AM

I don't have a story, I just want to post on this thread so I can look at ICDED's avatar. :poopoo:

Dangerous Dave 03-04-2015 11:38 AM

I had one go when the camshaft broke in half. Yup, the big end of the connecting rod came right up and broke it in half. At least I was able to keep the carb and intake.

dereknkathy 03-04-2015 11:50 AM

Bought a set of 2.02 heads. First time out intake valve broke head off. destroyed cyl 1. Beastie kept running the 30p yards to get me back to the dock...


All times are GMT -5. The time now is 06:58 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.