|
Video: testing at Jordanelle reservoir.
check out the view/water at 2 min 15 sec
Originally Posted by BigSilverCat
(Post 4603311)
|
Dead calm....deck camera from a 50' Skater on calm water is in keeping of the deck cam on a aircraft carrier.
Not many people can say they have ever gone to the lengths you have Tyson! |
Thanks for putting the time into sharing this thread it is the best. Great job you are doing on the boat . Wisseman were developing a 2 speed that was air operated and went onto an outboard trunk above the gearbox i saw it at SEMA back in 2010 or 2011, maybe they do one to go on an M8 .Good luck with this project it is absolutely the best thing I have ever seen online!
|
Crappy day there for sure. Mid to high 30's with a wintry mix coming down,
See a car at end of ramp so assuming they are still out there now? https://stateparks.utah.gov/parks/jo...nt-conditions/ |
Originally Posted by SB
(Post 4603334)
Crappy day there for sure. Mid to high 30's with a wintry mix coming down,
See a car at end of ramp so assuming they are still out there now? https://stateparks.utah.gov/parks/jo...nt-conditions/ |
What speed were you seeing around the 10 minute mark in the video?
Looking Good. |
Originally Posted by tommymonza
(Post 4603337)
What speed were you seeing around the 10 minute mark in the video?
Looking Good. if you notice the roost turns dark on the starboard side right at 9:40 that was when the turbo broke loose so the engine was not getting enough air to burn all the fuel and clean up the exhaust. |
Originally Posted by BigSilverCat
(Post 4603335)
we already left, here is the video of going back to industrial injections shop.
https://youtu.be/XPatqS4XFgo |
Originally Posted by HabanaJoe
(Post 4602067)
Tyson - a bit of advice and maybe you are doing it already but you should monitor exhaust manifold pressure (not back pressure but between exhaust ports and turbo) and that should be right along side boost pressure, you know boost has to be higher than exhaust, when it is not the engine can't breath anymore and things melt - again not an expert just years of looking over damage.
|
2 Attachment(s)
That starboard engine didn't look happy from the get go, it seemed to be steaming heavily at the start compared to the port.
Whats making to turbos let go? they should be the simplest part of the project if matched to the engine correctly and not over-speeding. Here's one of my turbos off my motors what size inducer and exducer you running? |
| All times are GMT -5. The time now is 05:47 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.