In Hull transducer help
 

I have a 1989 30' Regal Velocity Steve Stepp hull and just got a Garmin 741xs. I am looking to install an in-hull transducer but not sure if my hull is a cored hull. Any ideas?

Thanks

Cored... lol id edit your post... this is a tuff crowd up in here yo...

Call the manufacturer. Or sand a spot clean use some gum to hold it in position and test it in water you know the depth of, if it works mount it permanently...

I made the changes. Thanks.

You can royally screw up a post and we will still help you.. We are going to bust your balls about it, but we will still help.

It is kind of like how we w.ill laugh and cheer as our drunk buddy falls off the dock, but we aren't going too let him drown

We're cored hulls even offered in 1989?

Yes. I'm not sure about the regal velocitys, but my old 88 baja was cored and a buddy had 22 velocity that was an 80 something that was balsa cored.

I think most Velocity were all balsa cored. An in-hull transducer will not work right unless you cut through the first layer, grind/dig out the coring. Reglass it so that you seal the integrity of hull.
You can now epoxy the transducer housing to the hull.
Make sure when you insert it you get the angle correct in regards to the vee of the hull. I would think it is around 20 degrees or so.

Thank you for the help.