Doug Wright building new 35 foot cat
#21
Registered
Thread Starter
.
35RT Video #6
The putty-like material has dried and hardened. Milling has begun. This round of milling will cut the putty surface and get the mold closer to the CAD model specs.
http://youtu.be/TMVe6zT1fLQ
35RT Video #6
The putty-like material has dried and hardened. Milling has begun. This round of milling will cut the putty surface and get the mold closer to the CAD model specs.
http://youtu.be/TMVe6zT1fLQ
#22
Registered
Thread Starter
.
SportBoatNews by noli
Final milling of the 35RT tunnel will be completed and the milling of the sponson will begin today
SportBoatNews by noli
Final milling of the 35RT tunnel will be completed and the milling of the sponson will begin today
#23
Registered
Thread Starter
.
DougWright continues with the milling of the 35RT. This time he's doing one of the sponsons. Again, he's milling the mold directly bypassing the plug creation.
I know the video is not clear but you can begin to see the steps of the hull being cut into the foam.
There are markers on the three-piece mold to be sure that the alignment is precise.
http://www.youtube.com/watch?v=dIgE-cCWAEE
DougWright continues with the milling of the 35RT. This time he's doing one of the sponsons. Again, he's milling the mold directly bypassing the plug creation.
I know the video is not clear but you can begin to see the steps of the hull being cut into the foam.
There are markers on the three-piece mold to be sure that the alignment is precise.
http://www.youtube.com/watch?v=dIgE-cCWAEE
Last edited by noli; 12-31-2016 at 07:44 PM.
#24
Registered
Thread Starter
Last edited by noli; 12-31-2016 at 07:43 PM.
#25
Registered
Thread Starter
Last edited by noli; 12-31-2016 at 07:43 PM.
#27
Registered