anybody visited skater factory?
10-28-2002, 12:13 AM
#2
Registered
I have not been on a tour of the facility but there are a few buildings at their location in Douglas, Mi that I am guessing would push about 75000 square feet or so. I believe they build around 35 boats a year.
10-28-2002, 10:04 AM
#4
Registered
Platinum MemberJoin Date: Jan 2001
Location: Houston, TX
Posts: 2,411
Likes: 0
Received 0 Likes
on
0 Posts
I was there yesterday. I was out checking the area and stopped by.l saw some new Skater trailers around back.
Also had a mold of a V-bottom hull sitting outside in back upside down. Not sure if it was the new mold or what.
I peaked through the front door entrance and saw a what looked like a 28 Skater and a smaller v-bottom in side. Its hard to see inside the door windows from all the crap on the windows.
I didn't see any serious HARDWARE when I looked in.
It was ghost town with it being sunday. I'm sure they make plenty of money during the week.
Also had a mold of a V-bottom hull sitting outside in back upside down. Not sure if it was the new mold or what.
I peaked through the front door entrance and saw a what looked like a 28 Skater and a smaller v-bottom in side. Its hard to see inside the door windows from all the crap on the windows.
I didn't see any serious HARDWARE when I looked in.
It was ghost town with it being sunday. I'm sure they make plenty of money during the week.
Thread
Thread Starter
Forum
Replies
Last Post
Ms PatriYacht
General Boating Discussion
106
03-13-2005 07:50 PM
timucin
General Boating Discussion
2
12-06-2002 07:39 PM
