any designer out there???
#1
Registered
Thread Starter
Join Date: Oct 2002
Location: Lighthouse Point Fl
Posts: 791
Likes: 0
Received 0 Likes
on
0 Posts
any designer out there???
lets hear some of the things that you designed and made for baots...
i'll start... design full size swivel bluster for scarab and a pair of bluster seat that will work in a douglas skater and profile cat..
i'll start... design full size swivel bluster for scarab and a pair of bluster seat that will work in a douglas skater and profile cat..
#3
Guest
Posts: n/a
AHHH I worked at Team Scarab for 12 years and I
can say one thing for sure
Larry Smith would not allow any type of swivel
seat in a Scarab, All seats had to hard mount to
the floor.
A Second strange thing is
that he would not put a
Drain plug in any boat
Race or not that was built
at Team Scarab.
Im not trying to be a smart ass but thats just
how he is.
Mike J.
can say one thing for sure
Larry Smith would not allow any type of swivel
seat in a Scarab, All seats had to hard mount to
the floor.
A Second strange thing is
that he would not put a
Drain plug in any boat
Race or not that was built
at Team Scarab.
Im not trying to be a smart ass but thats just
how he is.
Mike J.
#4
Registered
Thread Starter
Join Date: Oct 2002
Location: Lighthouse Point Fl
Posts: 791
Likes: 0
Received 0 Likes
on
0 Posts
they were out of a 47 smith.. never changed anything about the seat that he made just made it beter...all the swiivel is mounted harder than he every did below deck.. sorry i am dyslexic
Last edited by CustomRigger101; 11-01-2002 at 07:15 PM.
#6
Registered
Thread Starter
Join Date: Oct 2002
Location: Lighthouse Point Fl
Posts: 791
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Steve 1
101 forgive Cat
More points around here are awarded for “Originality” and” Intent” than spelling!
101 forgive Cat
More points around here are awarded for “Originality” and” Intent” than spelling!
#7
Registered
Thread Starter
Join Date: Oct 2002
Location: Lighthouse Point Fl
Posts: 791
Likes: 0
Received 0 Likes
on
0 Posts
ok here's another for you... say a guy nails a log.. everyone hits something sometime.. take our racks and lay them out and cut them back.. down the sides,, drop the back half.. cut back the your beams.. where am i going???????????
#8
rigging on your own SUCKS!! We had to reposition the sea strainers a couple of times, drill bigger holes for the exhaust, replace guages, drill new holes for the port engine's motor mounts. I do not envy you if it is your profession.
#9
Registered
Join Date: Oct 2001
Location: Toledo Oh
Posts: 1,915
Likes: 0
Received 0 Likes
on
0 Posts
About 8 years ago I replaced all the teak on my old Scarab with 3/4 inch thick cuting board from work. Looked very cool and easy to work with. Now they are selling the stuff as Starboard for about 4 times what its worth. You can buy it from a butcher supply house for a fraction of the cost as West or BoatUs.