Originally Posted by noli
(Post 4756132)
|
https://cimg4.ibsrv.net/gimg/www.off...fdb6629d5.jpeg
https://cimg5.ibsrv.net/gimg/www.off...41d11bfc6.jpeg 2020 Skater 368 at LOTO Supercat. Purpose built for big water With outboard cut. Not as low as Rice 368 but very comfortable cut. She’s a big girl that loves big water. . Photo credit J Helmkamp |
Originally Posted by Skater30
(Post 4756134)
Yes
so it was Rice that started the 368 outboard craze, I followed that build thread, was def ahead of its time! had buggerman flying up to Skater factory to be sure the planned rigging is consistent with the build specs . |
|
Motors in the tunnel doesn't seem like a good setup.
|
Originally Posted by NWfreerider
(Post 4756898)
Motors in the tunnel doesn't seem like a good setup.
|
Originally Posted by NWfreerider
(Post 4756898)
Motors in the tunnel doesn't seem like a good setup.
|
^^^^ listed on the 36 Skater thread taking the boat from trips to quads - but it wasn't just a matter of hanging an extra mount on the back
https://www.offshoreonly.com/forums/...oject-112.html |
Originally Posted by speicher lane
(Post 4756909)
|
The 36 had 2 pods installed in front of the mids so they (apparently) do not take the same beating as a trip where the center engine is literally being pushed off the transom with side loading as much as the engine is trying to push the boat.
Quite a few Nor-tech's has the i/o power pulled for quad OB's https://www.speedonthewater.com/proj...ado-outboards/ - granted they were rigged behind the sponson but then again, the 40ss shown is just a paint rendering (not necessarily what the final rigging will be) + 40SS is a big hull. that may be actually rigged like the Nor-tech |
All times are GMT -5. The time now is 06:31 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.