My engines/drives in the classifieds
#1
Registered
Thread Starter
Join Date: Oct 2000
Location: Greenwich CT. U S of A
Posts: 1,845
Likes: 0
Received 0 Likes
on
0 Posts
My Cigarette Engines & SSM3A drives in the classified section.
I have been dealing with the buyer of my Cig for a little over a month (deposit in hand) & he has decided he wants really big power & #6 drives.
He has given me a reasonable offer on the hull so I have listed my twin 625hp motors, SSM 3A drives/gimbals/trim pistons/transom plates in the classified section.
I can't believe I'm going to take it apart!!!!!
Any final offers on the full package?
He has given me a reasonable offer on the hull so I have listed my twin 625hp motors, SSM 3A drives/gimbals/trim pistons/transom plates in the classified section.
I can't believe I'm going to take it apart!!!!!
Any final offers on the full package?
Last edited by DJD; 01-27-2003 at 09:47 PM.
#3
Registered
Thread Starter
Join Date: Oct 2000
Location: Greenwich CT. U S of A
Posts: 1,845
Likes: 0
Received 0 Likes
on
0 Posts
Too Old, INSANE is an understatement (as far as I am concerned).
Paint is perfect, engines/compartment spotless, SSM3A drives are fresh, motors are perfect & purr like kittens/run like lions. Nevermind the rest of the new parts, goodies & trailer that go along with it.
I have till this weekend to give the new owner the word. "It's yours" or "your smoking crack".
If I run the numbers, $28500 hull. Then I sell the drives/gimbals/steering/tie bar/ trim pistons etc... (price in the classifieds board gods!!!!!!!!!)
Then fully dressed Engines including Stailess Marine exhaust, alts, starters, blowers, belts & Nickersen carbs. THEN transmissions....ALL IN THE classifieds...........
(I don't want to get POOFED)
Paint is perfect, engines/compartment spotless, SSM3A drives are fresh, motors are perfect & purr like kittens/run like lions. Nevermind the rest of the new parts, goodies & trailer that go along with it.
I have till this weekend to give the new owner the word. "It's yours" or "your smoking crack".
If I run the numbers, $28500 hull. Then I sell the drives/gimbals/steering/tie bar/ trim pistons etc... (price in the classifieds board gods!!!!!!!!!)
Then fully dressed Engines including Stailess Marine exhaust, alts, starters, blowers, belts & Nickersen carbs. THEN transmissions....ALL IN THE classifieds...........
(I don't want to get POOFED)
#4
speel chekk this fokker!
Charter Member
Join Date: Feb 2001
Location: Locust Valley, New York
Posts: 5,329
Likes: 0
Received 0 Likes
on
0 Posts
ouch man!!!
i hate to see you rip her apart to sell it. I wish i had the $$$ to buy her off you whole. But right now its just not in the cards.
i hate to see you rip her apart to sell it. I wish i had the $$$ to buy her off you whole. But right now its just not in the cards.
__________________
Pardon me, while I whip this out!
Pardon me, while I whip this out!
#6
Registered
Thread Starter
Join Date: Oct 2000
Location: Greenwich CT. U S of A
Posts: 1,845
Likes: 0
Received 0 Likes
on
0 Posts
I looked up all the legal mumbo jumbo about dealers selling used vehicles & found they made a few big (technical) legal mistakes.
I put it all in writing & tossed in a few things like Interstate wire fraud, law suits, Bstter Business Bureau, State attorney General charges re: consumer fraud and a few others.
I was paid in full for all out of pocket repair & travel expenses
I put it all in writing & tossed in a few things like Interstate wire fraud, law suits, Bstter Business Bureau, State attorney General charges re: consumer fraud and a few others.
I was paid in full for all out of pocket repair & travel expenses
Thread
Thread Starter
Forum
Replies
Last Post
SLINGSHOT
General Boating Discussion
2
11-18-2002 08:56 PM