rbtnt

I copied US1 Fountain's design to make mine. This one is quite a bit higher than his.

US1 Fountain

iTrader: (1)

Nice! You are the 4 th person that has copied one of my ideas and I have yet to recieve any 'appreciative jestures'. (read between the lines->) -----------$$$$$$$$$$$$-----------

I don't see a way to adjust for different heights, other than trailer tongue jack on yours.

rbtnt

My first one was made with a floor jack and it worked fine on my last boat where the drive was close to the ground. My drives on this boat are pretty high and the center of gravity was too high for the floor jack to handle safely.

Mr Gadgets

Ok.. it is scheduled to go in for a custom paint job, But my day job has had me a bit busy. Soon as my new shop get organized, I will update it.
It does work, crude but works. I have started working on drives again, even though the new shop is not completed..

Dick

Scarab105

I think something like Too Old has attached a photo of will clamp on my mtc\atv jack to allow me to put the drive on by myself. Maybe I just need to get the welder
out and make one. I thought there was someone who make them commercially.

Sea Ya

Make it high and wide enough for a motorcycle lift slide under.

Scarab105

Good idea. Something else that would be good is some
kind of screw system like a transmission jack that will
allow you to tilt from side to side and back and forth.

KCHOTBOAT

Jim Kruse built that one day real quick for me one day. It is even powder coated to match the drive. Works great.

Hi-Tech Marine

My father is building one similar to post 21 with the ability to raise/lower and tilt by hydraulic as well.

Will post a pic when complete.

Half Nutz

Here's a pic of my homemade stand.