Need Measurements Please
#1
Charter Member #232
Charter Member
Thread Starter
Need Measurements Please
Hey guys my bolsters just arrived the other day and now I am trying to figure out were to put them so that I can continue on with my fairing and dash project. What I am looking for is the measurement from the front of the dash to the front of the seat and also the distance from the steering wheel to the back of the seat (were your back rests into). Any help would be great so that I can get back on this thing
Jon
Jon
__________________
Put your best foot forward!
Put your best foot forward!
#3
Banned
Join Date: Sep 2001
Location: Deland, Florida
Posts: 25,191
Likes: 0
Received 0 Likes
on
0 Posts
It's raining right now, but it has been intermittent all day, when it stops, I'll get up in there and measure for you.
I'm working on replacing the lines to the k planes in between the rain. I got my rounded off one out finally. I took the ram off, cut the old hose, then drove a six point 9mm socket on it, hooked a 15 inch crescent wrench through the handle of the socket wrench and twisted it out. It was plumb easy.
I'm working on replacing the lines to the k planes in between the rain. I got my rounded off one out finally. I took the ram off, cut the old hose, then drove a six point 9mm socket on it, hooked a 15 inch crescent wrench through the handle of the socket wrench and twisted it out. It was plumb easy.
#4
Charter Member #232
Charter Member
Thread Starter
Aint they fun Cuda!!! I would love the measurements off your boat as the dash should be the same. Thanks
Jon
Jon
__________________
Put your best foot forward!
Put your best foot forward!
#8
Banned
Join Date: Sep 2001
Location: Deland, Florida
Posts: 25,191
Likes: 0
Received 0 Likes
on
0 Posts
I took this measurement in case yours didn't have the footrest. From the front to the leg is 30.5".
Before everyone jumps on me abou the leaves in the boat, they all blew in today while working on the boat. It's windy and cold here today.
Before everyone jumps on me abou the leaves in the boat, they all blew in today while working on the boat. It's windy and cold here today.
Last edited by cuda; 03-30-2003 at 02:21 PM.