O2 Sensor & CMi's
#1
Registered
Thread Starter
Join Date: Sep 2001
Location: Houston, TX, USA
Posts: 2,287
Likes: 0
Received 0 Likes
on
0 Posts
O2 Sensor & CMi's
I am getting ready to go EFI. I am going to have a wide band O2 Sensor. Does any one know where it needs to go on the cmi etops? If you had it done who did it?
#3
Registered
Join Date: Oct 2002
Location: Menasha,WI
Posts: 285
Likes: 0
Received 0 Likes
on
0 Posts
Many of the single O2 sensors are mounted in the inside of the elbow or collector. If sensors are to be used in each primary tube they are about six inches from the head flange.
#4
Registered
Thread Starter
Join Date: Sep 2001
Location: Houston, TX, USA
Posts: 2,287
Likes: 0
Received 0 Likes
on
0 Posts
Getting only one sensor. I was thinging that it was to go in the collector after each primary tube come together, somewhere in the elbow. I just did not know top, side, underside or what. I had never thougth about in the primary tube.
#5
Platinum Member
Platinum Member
Getting the welding done right on a primary tube would be dang near impossible after the headers were built.
You almost gotta put it near a joint or flange, where you can get the tip of the Tig torch in there to it.
You almost gotta put it near a joint or flange, where you can get the tip of the Tig torch in there to it.
Thread
Thread Starter
Forum
Replies
Last Post
Rage
General Q & A
11
08-06-2007 01:44 PM