Surface Drive Gif
#4
Registered
Thread Starter
I'm not finished yet... the transom plat is getting bigger and the rudder is getting smaller..... the thing is the difficulty of actually making something like this and the turning it into a gif.
Ernie
I do this in my spare time, so I can't practice much.
Ernie
I do this in my spare time, so I can't practice much.
#6
Registered
Thread Starter
Here is a link to the .dwg file. Please don't splash it. If you make any improvements pleas e-mail them to
[email protected]
http://tamug.tamu.edu/~egk9566/CAD/surfdrvedne.dwg
[email protected]
http://tamug.tamu.edu/~egk9566/CAD/surfdrvedne.dwg
#8
VIP Member
Platinum Member
sounds doable, no skeg to guard prop not a good thing for the prop, But is a good thing for top speed
I have it in AUTOCAD 2004 right now 3d rotated
pretty neat Idea
I have it in AUTOCAD 2004 right now 3d rotated
pretty neat Idea
#9
Registered
Thread Starter
check this out.. I had a little time after school and was just goofing around.
Ernie
Well it looks like the page can't handle it... it is fine here on my computer.... I'll try again later.
Ernie
Well it looks like the page can't handle it... it is fine here on my computer.... I'll try again later.
Last edited by TopSpin80; 11-21-2003 at 05:24 PM.