Best solution for replacing 502 stock manifold/risers?
#1
Registered
Thread Starter
Join Date: Dec 2000
Location: Bell Canyon, CA
Posts: 12,754
Likes: 0
Received 0 Likes
on
0 Posts
Best solution for replacing 502 stock manifold/risers?
I want to replace the stock 502MAG manifold and risers. Looking for "no worries" and not having to do regular gasket replacing.
IMCO?
EddieMarine?
Needs three sets.......
IMCO?
EddieMarine?
Needs three sets.......
#3
Guest
Posts: n/a
I have Stainless Marine w/polished s/s risers. They came with all hardware for shifters, oil filter breackets, etc., and they fit perfectly no tweaking or anything. I only paid like $1500 for 502 EFI/MP MAG. I actually gained about 200 rpm and 1-2 mph. Have not had any problems yet. Check the price on this site:
http://www.perfprotech.com/
http://www.perfprotech.com/
#4
Performance Boat Center
VIP Member
I have Stainless Marines... Make sure you ge the stainless risers that drop back far enough to keep water from reverting...
__________________
Tim Gallagher
Performance Boat Center-FL
[email protected]
954-809-8739
Wright Performance, MTI, Cigarette, Sunsation
Tim Gallagher
Performance Boat Center-FL
[email protected]
954-809-8739
Wright Performance, MTI, Cigarette, Sunsation
#6
#7
CBPBA's Walmart Greeter
VIP Member
I went with the Gil Offshore Exhaust. Paid a bloody fortune for them, but they're pretty much maintenance free. After 6 years I put them on my new engines, bought a new gasket and turbulator ring for each. The originals turb rings were fine, but I preferred starting from scratch. The rest of the system was like new after 6 seasons on the Chesapeake, incredible quality imho.
I have heard good things about the Stainless Marine setup, less expensive too. In any case, didn't notice any performance enhancement on my end. Carb'd engines in mine.
Hey Tim, you're signature link is blowing the frame off the screen, can't see full page without horizontal scroll.
I have heard good things about the Stainless Marine setup, less expensive too. In any case, didn't notice any performance enhancement on my end. Carb'd engines in mine.
Hey Tim, you're signature link is blowing the frame off the screen, can't see full page without horizontal scroll.
__________________
K2
-----------------------------------------
CHESAPEAKE BAY POWER BOAT ASSOCIATION
'http://www.cbpba.com'
"Experience is something you don't have until just after you need it."
K2
-----------------------------------------
CHESAPEAKE BAY POWER BOAT ASSOCIATION
'http://www.cbpba.com'
"Experience is something you don't have until just after you need it."