50 MPH Bimini Specs
#11
CBPBA's Walmart Greeter
VIP Member
Stainless all the way Randy, can show you the setup I have in about another 5 weeks.
__________________
K2
-----------------------------------------
CHESAPEAKE BAY POWER BOAT ASSOCIATION
'http://www.cbpba.com'
"Experience is something you don't have until just after you need it."
K2
-----------------------------------------
CHESAPEAKE BAY POWER BOAT ASSOCIATION
'http://www.cbpba.com'
"Experience is something you don't have until just after you need it."
#13
Registered
Join Date: Nov 2001
Location: Palm Harbor, FL
Posts: 3,959
Likes: 0
Received 0 Likes
on
0 Posts
Inprop - I have a Bimini that is made with 1" Stainless Steel with red Sunbrella. I have had this on many over 60 runs with -0- problems. It fit's a 8' Beam that came of my old 250 Sport Baja. It also has a boot that goes with it. Let me know if you are interested. Dave
[email protected]
[email protected]
#14
Toxic FORMULA
Platinum Member
The secret to it is to have the bimini at the correct angle.
It should be level with the running attitude if the boat. This way it cuts through the air.
Too high in the front it will act like a hang glider and lifts. 2002 I saw the results of one that ripped the windshield off. Driver wound up with a # of stitches in his face and a ruined vacation
With my front curtains on , I hold it down to 40/45. Besides it's probably raining and the visibility is reduced.
And cuda , I very rarely run with it up. Also lay it down on the engine hatch when not in use.
It should be level with the running attitude if the boat. This way it cuts through the air.
Too high in the front it will act like a hang glider and lifts. 2002 I saw the results of one that ripped the windshield off. Driver wound up with a # of stitches in his face and a ruined vacation
With my front curtains on , I hold it down to 40/45. Besides it's probably raining and the visibility is reduced.
And cuda , I very rarely run with it up. Also lay it down on the engine hatch when not in use.
Last edited by mopower; 02-22-2004 at 12:19 PM.