|
Originally posted by Reed Jensen If you are thinking of polishing the little nooks and crannies of a intake manifold... you will need some abrasive wheels called "craytex".. or Kraytex.. or you can go with the same thing from a company near me called Matz rubber in Burbank ca....213 849-5170... that may be an old phone number... but I'm sure they are still in Burbank.. they manufacture the rubber wheels and "points" that fit on a 1/4 inch mandrel... they have abrasive impregnated in the rubber and are used for polishing... good luck. |
Dude you have to work on your titles cuz guys with sick minds like me just want to make fun of you :D:D
|
Originally posted by Audiofn Dude you have to work on your titles cuz guys with sick minds like me just want to make fun of you :D:D |
Originally posted by Cord Grainger has em. http://www.grainger.com/Grainger/searchresults.jsp I assume McMaster would too. I have the Grainger ones at home if you want a part number. Don't buy this tool expecting to polish your intake manifold. You'll burn out a smaller compressor and freeze your hand off. The link failed and when I went to Grainger I had difficulty. Can you resend? Thanks |
Polishing a manifold is one dirty messy time consuming job.... lucky for me... there are two "polishing" shops just a few minutes from me..... I just take the stuff to them and get it back a few days later.... :D
|
Shane, I can send you my catalog of the stuff you are looking for....Give me a call 586-771-3200.
Mike |
| All times are GMT -5. The time now is 10:28 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.