What the heck am I up to now?
 

Mrs took this pic for me this morning. Took us almost two full days to get these sand bags in place. With some luck we'll be able to show you tomorrow. Any guesses? :D

Re: What the heck am I up to now?
 

You're going fishing with Scott Peterson???

Re: What the heck am I up to now?
 

moving? you want the sand bags at the new house thats in the flood plane too....

Re: What the heck am I up to now?
 

Maybe you want to stick it in the water to see where the waterline is for graphics?
Or are setting it up to balance the trailer?
Or, as some guys near me did, you need to move it by water (they had 1 engine in though and ballasted for the other). Except when they put the drives on they forgot to plug the hoses properly and it sank. DOH!!!
cheers...M

Re: What the heck am I up to now?
 

That's good! But, I'd want concrete anchors. Freekin' moron. :rolleyes:

Dyno-we ain't down south here! I only move gravel in my boat! :D



Guys-I promise that this will be very trick and will get comments! Maybe not complements, but comments! :D

Re: What the heck am I up to now?
 

You want a new boat and you're going to be convicted of insurance fraud after you sink this one. :blaster:

Re: What the heck am I up to now?
 

That would cure chine walk. :D

Re: What the heck am I up to now?
 

Dont let the DEA see that!

Re: What the heck am I up to now?
 

Yea, but just don't tell anyone! ;)

Re: What the heck am I up to now?
 

Your taking sand to the beach.

Re: What the heck am I up to now?
 

Maybe gluing in a new floor/diamond plate

Re: What the heck am I up to now?
 

That was my guess. :drink:

Re: What the heck am I up to now?
 

Ding, Ding! We got a winner! :D

Re: What the heck am I up to now?
 

Cord.. what adhesive did you use for the diamond plate?

Re: What the heck am I up to now?
 

I used Pl Premium. I saw a cured sample of the stuff and I couldn't pull the stainless off. They make a dispenser tip that helps to spread the stuff a bit more evenly. Try for 100% coverage. Oh, and you need to mist the surface with some water to set the eurethane.

BTW-I never said it was diamond plate! It's not rubber either. :D

Re: What the heck am I up to now?
 

whatever happend to this little project....

im still trying to figure out what all those sand bags have to do with putting in a new floor....

Re: What the heck am I up to now?
 

come on cord... spill it.

Re: What the heck am I up to now?
 

It turned out nice. I stood on it, spilled gas, ATF, and oil on it a week ago!